SNPUSSSlide-in coupling

Areas of use:

• To eliminate the accurate length cutting of ducts which the ordinary NPUSS connector sometimes requires when joining SRSS ducts. In this case the slide-in coupling shall be secured with screws.
• To make it possible to use a duct that is cut to a too short length – instead of having to cut a new duct to the correct length. In this case the slide-in coupling shall be secured with screws.
• To assist when joining two ducts which run towards each other. E.g. when building a system from two opposing directions. In this case the slide-in coupling shall be secured with screws.
• To assist when inserting or adding an other product into an existing system. E.g. the addition of a new piece of duct to replace a damaged part. In this case the slide-in coupling shall be secured with screws.

The product is CE marked according to EN 12101-7 and used in a circular smoke control system - single compartment (see declaration of performance).